Flood Fill Tool
Publish date: 2024-05-06
Flood Fill ToolThe Flood Fill Tool allows you to fill in areas of your page, selection, or object with a single click.
The Flood Fill Tool works by replacing the color of pixels on the current layer with the Fill color set on the Color panel. The pixels affected are determined by the following:
- The color of the pixel under the tool when you click on your page.
- Whether the pixels are within the same selection area.
- The pixels are directly connected to the clicked pixel or any others that are affected.
- The tool's Tolerance settings (see below).
Settings
The following settings can be adjusted from the context toolbar:
- Tolerance—sets the range of pixels affected (filled) when a pixel is clicked. For lower tolerance settings, pixels must be very close in value to the clicked pixel. For higher tolerance settings, pixel color can vary widely from the clicked pixel.
- Contiguous—if enabled, the flood will only be applied to affected pixels that are in the same area of the image. If disabled, the flood will be applied to all the pixels that match the tolerance setting regardless of where they are in the image.
SEE ALSO:
ncG1vNJzZmirY2KytnnWnqqtZWFjrq6t2ailmq%2BjY7CwuY6anZ%2Bhnp7BunnDqJqsZ5iaubF7z6GmradfmrtuobJno6mqn598sa3GnqpojJ%2BkubR706impauPm7mwu8N%2FoKWkXp3Brrg%3D